Skip to main content
Express delivery
Available in Australia

BUY NOW, PAY LATER.

Shop

Cartek dash mounted shift light

$230.00

The Cartek dash mounted sequential shift light can be programmed to display the drivers preferred rpm range for up shifting to the next gear to gain maximum performance from the engine. As the shift point gets close the outer green lights light up followed by the amber lights then finally the central red light illuminates at the optimum revs to change gear. The revs at which these lights illuminate is easily settable by the user. The shift light unit is fully waterproof so is fine for use in open cockpit cars and installation is simple, with only 3 electrical connections required.

Out of stock

SKU: CTKCK-LS-07 Category:

The Cartek dash mounted sequential shift light can be programmed to display the drivers preferred rpm range for up shifting to the next gear to gain maximum performance from the engine. As the shift point gets close the outer green lights light up followed by the amber lights then finally the central red light illuminates at the optimum revs to change gear. The revs at which these lights illuminate is easily settable by the user. The shift light unit is fully waterproof so is fine for use in open cockpit cars and installation is simple, with only 3 electrical connections required.

Setup is Easy!
The CARTEK Shift Light uses an RPM Signal, 12V Power, and Ground. An extra white wire is used to put the unit into setup mode. This is achieved by touching the setup wire to chassis earth, and then start the engine. Two outer green LED’s will begin to flash – this will only happen in setup mode.

First you store the lower RPM of the sequence. To do this raise the revs to your starting point and then immediately reduce the revs. The Shift Lights will have stored the RPM that you want to start at.

Then touch the setup wire to chassis earth, and then raise your revs to the highest point you want the Shift Lights to finish at. Immediately reduce the revs again and the Shift Lights will have stored the highest RPM.

Finally, you touch the setup wire to chassis earth to finish the setup mode. It will calculate all intermediate LED levels of the sequence and will be ready to use.